How to repair and maintain the cone crusher

Compared with traditional crushers, cone crushers have higher technological content. At the same time, they are also a popular equipment in contemporary times. They can crush and process many types of materials, and their work efficiency is very high. Therefore, user satisfaction with them is also quite high, so this equipment is the mainstream of contemporary crushing equipment.
In order to prolong the service life of this device, we should pay attention to maintenance and upkeep during normal use. So how should the cone crusher be repaired and maintained? The following will provide a detailed introduction to the maintenance methods of cone crushers.

How to repair and maintain the cone crusher:
1. When the material that needs to be crushed by the cone crusher is damp or has a high moisture content, the fixing bolts for fixing the dust seal slip ring should be checked frequently;
2. To produce at full capacity, otherwise there may be a phenomenon of product particles being too coarse;
3. Regularly replace the lubricating oil and avoid being too dirty. If it is too dirty, it will accelerate the wear of gears, bowl shaped tiles, shaft sleeves, and even cause the shaft sleeves to grind;
4. The fixing condition of the sliding ring should be regularly checked to prevent a large amount of dust and mineral sand from entering the equipment body due to the failure of the sliding ring of the dustproof sealing box during cone breaking operation, which may affect the operation of the equipment or even cause serious equipment failures;
5. Water in the oil of the crusher can cause the oil level in the oil tank to rise. The water pressure in the cooler is higher than the oil pressure, the cooler leaks water, the water supply to the water seal is too large, or the water supply pipe is blocked, all of which can cause water to mix in the conical oil, causing the oil level in the oil tank to "be forced to rise". In response to this situation, everyone can adjust the water pressure to be slightly lower than the oil pressure; Check and repair the leaking parts; Adjust the water supply volume; Clean the return water circuit and oil tank, and replace them with new oil.

The above is an introduction to how to repair and maintain the cone crusher, hoping to be helpful to everyone. Maintenance and upkeep are some trivial matters, but it is precisely these ordinary trivial matters that affect the normal operation and service life of the equipment.